🔍

200-301 — questions

Page 48 of 60 · 1182 total questions.

200-301 Question 1049

Single page →
Topic 1 · Question 1049

Refer to the exhibit. What is occurring on this switch?

Exhibit 1 for question 1049
  • AFrames are dropped after 16 failed transmission attempts (correct answer)
  • BThe internal transmit buffer is overloaded
  • CA high number of frames smaller than 64 bytes are received
  • DAn excessive number of frames greater than 1518 bytes are received
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: Frames are dropped after 16 failed transmission attempts

Explanation

OSPF elects a designated router on multiaccess networks to reduce adjacency and LSA exchange overhead.

200-301 Question 1050

Single page →
Topic 1 · Question 1050

Refer to the exhibit SW_1 and SW_12 represent two companies that are merging. They use separate network vendors. The VLANs on both sides have been migrated to share IP subnets. Which command sequence must be issued on both sides to join the two companies and pass all VLANs between the companies?

Exhibit 1 for question 1050
  • Aswitchport mode trunkswitchport trunk encapsulation dot1q (correct answer)
  • Bswitchport mode trunkswitchport trunk allowed vlan allswitchport dot1q ethertype 0800
  • Cswitchport mode dynamic desirableswitchport trunk allowed vlan allswitchport trunk native vlan 7
  • Dswitchport dynamic autoswitchport nonegotiate
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: switchport mode trunkswitchport trunk encapsulation dot1q

Explanation

A trunk carries traffic for multiple VLANs between network devices.

200-301 Question 1051

Single page →
Topic 1 · Question 1051

An engineer is configuring a switch port that is connected to a VoIP handset. Which command must the engineer configure to enable port security with a manually assigned MAC address of abcd.abcd.abcd on voice VLAN 4?

  • Aswitchport port-security mac-address abcd.abcd.abcd vlan 4
  • Bswitchport port-security mac-address abcd.abcd.abcd vlan voice
  • Cswitchport port-security mac-address abcd.abcd.abcd (correct answer)
  • Dswitchport port-security mac-address sticky abcd.abcd.abcd vlan 4
Reveal answer & explanation
Correct answer: C

The correct answer is C. Option C: switchport port-security mac-address abcd.abcd.abcd

Explanation

OSPF elects a designated router on multiaccess networks to reduce adjacency and LSA exchange overhead. This option keeps traffic private / properly secured as required.

200-301 Question 1056

Single page →
Topic 1 · Question 1056

What is represented by the word "LB20" within this JSON schema?

Exhibit 1 for question 1056
  • Avalue (correct answer)
  • Barray
  • Cobject
  • Dkey
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: value

200-301 Question 1057

Single page →
Topic 1 · Question 1057

What is represented beginning with line 1 and ending with line 5 within this JSON schema?

Exhibit 1 for question 1057
  • Akey
  • Bobject
  • Carray (correct answer)
  • Dvalue
Reveal answer & explanation
Correct answer: C

The correct answer is C. Option C: array

200-301 Question 1058

Single page →
Topic 1 · Question 1058

What is represented by the word "IDS" within this JSON schema?

Exhibit 1 for question 1058
  • Aobject
  • Bvalue
  • Carray
  • Dkey (correct answer)
Reveal answer & explanation
Correct answer: D

The correct answer is D. Option D: key

200-301 Question 1059

Single page →
Topic 1 · Question 1059

What is represented in line 4 within this JSON schema?

Exhibit 1 for question 1059
  • Aobject (correct answer)
  • Barray
  • Ckey
  • Dvalue
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: object

200-301 Question 1060

Single page →
Topic 1 · Question 1060

What is represented by the word "port" within this JSON schema?

Exhibit 1 for question 1060
  • Akey (correct answer)
  • Bvalue
  • Carray
  • Dobject
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: key

200-301 Question 1061

Single page →
Topic 1 · Question 1061

What provides connection redundancy, increased bandwidth, and load sharing between a wireless LAN controller and a Layer 2 switch?

  • Afirst hop redundancy
  • BVLAN trunking
  • Ctunneling
  • Dlink aggregation (correct answer)
Reveal answer & explanation
Correct answer: D

The correct answer is D. Option D: link aggregation

200-301 Question 1063

Single page →
Topic 1 · Question 1063

Which interface is used to send traffic to the destination network?

Exhibit 1 for question 1063
  • AF0/5
  • BF0/6
  • CF0/12 (correct answer)
  • DF0/9
Reveal answer & explanation
Correct answer: C

The correct answer is C. Option C: F0/12

200-301 Question 1064

Single page →
Topic 1 · Question 1064

What is the purpose of an SSID?

  • AIt identifies an individual access point on a WLAN.
  • BIt differentiates traffic entering access points.
  • CIt provides network security.
  • DIt identifies a WLAN. (correct answer)
Reveal answer & explanation
Correct answer: D

The correct answer is D. Option D: It identifies a WLAN.

200-301 Question 1065

Single page →
Topic 1 · Question 1065 · Select all that apply

Which two types of attack are categorized as social engineering? (Choose two.)

  • Aphoning
  • Bmalvertising
  • Cprobing
  • Dpharming (correct answer)
  • Ephishing (correct answer)
Reveal answer & explanation
Correct answer: D, E

The correct answer is D, E. Option D: pharming Option E: phishing

200-301 Question 1067

Single page →
Topic 1 · Question 1067

What describes the functionality of southbound APIs?

  • AThey enable communication between the controller and the network device. (correct answer)
  • BThey communicate with the management plane.
  • CThey use HTTP messages to communicate.
  • DThey convey information from the controller to the SDN applications.
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: They enable communication between the controller and the network device.

Explanation

Controller-based networking centralizes policy and exposes programmable management interfaces.

200-301 Question 1068

Single page →
Topic 1 · Question 1068

Refer to the exhibit. A network engineer is verifying the settings on a new OSPF network. All OSPF configurations use the default values unless otherwise indicated. Which router does the engineer expect will be elected as the DR when all devices boot up simultaneously?

Exhibit 1 for question 1068
  • AR1
  • BR2
  • CR3
  • DR4 (correct answer)
Reveal answer & explanation
Correct answer: D

The correct answer is D. Option D: R4

200-301 Question 1069

Single page →
Topic 1 · Question 1069

Which command must be entered so that the default gateway is automatically distributed when DHCP is configured on a router?

  • Adns-server
  • Bdefault-router (correct answer)
  • Cip helper-address
  • Ddefault-gateway
Reveal answer & explanation
Correct answer: B

The correct answer is B. Option B: default-router

200-301 Question 1070

Single page →
Topic 1 · Question 1070 · Select all that apply

What are two functions of a firewall within an enterprise? (Choose two.)

  • AIt enables traffic filtering based on URLs. (correct answer)
  • BIt serves as an endpoint for a site-to-site VPN in standalone mode. (correct answer)
  • CIt provides support as an endpoint for a remote access VPN in multiple context mode.
  • DIt offers Layer 2 services between hosts.
  • EIt enables wireless devices to connect to the network.
Reveal answer & explanation
Correct answer: A, B

The correct answer is A, B. Option A: It enables traffic filtering based on URLs. Option B: It serves as an endpoint for a site-to-site VPN in standalone mode.

200-301 Question 1071

Single page →
Topic 1 · Question 1071

What is the maximum number of concurrent Telnet sessions that a Cisco WLC supports?

  • A3
  • B5 (correct answer)
  • C6
  • D15
Reveal answer & explanation
Correct answer: B

The correct answer is B. Option B: 5

200-301 Question 1072

Single page →
Topic 1 · Question 1072

Which 802.11 management frame type is sent when a client roams between access points on the same SSID?

  • AReassociation Request (correct answer)
  • BAuthentication Request
  • CAssociation Request
  • DProbe Request
Reveal answer & explanation
Correct answer: A

The correct answer is A. Option A: Reassociation Request

200-301 Question 1073

Single page →
Topic 1 · Question 1073

What is a functionality of the control plane in the network?

  • AIt looks up an egress interface in the forwarding information base.
  • BIt forwards traffic to the next hop.
  • CIt exchanges topology information with other routers. (correct answer)
  • DIt provides CLI access to the network device.
Reveal answer & explanation
Correct answer: C

The correct answer is C. Option C: It exchanges topology information with other routers.

200-301 Question 1074

Single page →
Topic 1 · Question 1074

Refer to the exhibit. All switches are configured with the default STP priorities. During the STP elections, which switch becomes the root bridge if all interfaces are in the same VLAN?

Exhibit 1 for question 1074
  • AMDF-DC-1: 0d:E0:43:96:02:30
  • BMDF-DC-2: 0d:0E:18:1B:05:97 (correct answer)
  • CMDF-DC-4: 0d:E0:19:A1:B3:19
  • DMDF-DC-3: 0d:0E:18:2A:3C:9D
Reveal answer & explanation
Correct answer: B

The correct answer is B. Option B: MDF-DC-2: 0d:0E:18:1B:05:97

Showing questions 941–960 of 1182 · Page 48 of 60